FNSW-2400PS
29 พฤศจิกายน 2560
ผู้ชม 864 ผู้ชม
Cost-effective Edge Network Connection Solution
To provide enhanced network management with cost saving benefit to customers, PLANET has released a new version of the FNSW-2400PS, the Layer 2 Web Smart Switch with PoE injector function. The FNSW-2400PS is equipped with 24 Fast Ethernet ports integrated with PoE injector function. With 125-watt PoE power budget, it provides a compact, affordable, safe and reliable power solution for small to medium enterprises.
IEEE 802.3af Power over Ethernet Support
The PoE in-line power following the IEEE 802.3af standard makes the FNSW-2400PS able to deliver power to 24 PoE compliant devices at the distance up to 100 meters through the 4-pair Cat 5/5e UTP wire. It optimizes the installation and safe power management of network devices such as wireless access points (AP), Voice over IP (VoIP) phones and IP surveillance cameras. With more efficient switching power supply, the efficiency of the FNSW-2400PS would be much better than four linear power adapters in the long run and offer customers the key benefit – energy saving.
Easy Cabling Installation
The Power over Ethernet technology enables the Ethernet wire to carry both data and power. Thus, the FNSW-2400PS reduces the need for cable installation and eliminates the need for extension cords or electrical outlets on the wall, ceiling or any unreachable place. In all, it lowers the installation costs and simplifies the deployment effort.
Friendly Web-based Management
For efficient management, the FNSW-2400PS is equipped with remote Web interface. It can be programmed for advanced switch management functions such as port configuration, VLAN, Rapid Spanning Tree Protocol (RSTP), IGMP Snooping, port trunk, QoS, bandwidth control, and MAC address / TCP & UDP filter. The FNSW-2400PS provides port-based / IEEE 802.1Q / MTU VLAN (port based / IEEE 802.1Q VLAN including overlapping). The VLAN groups allow the FNSW-2400PS to have a maximum of up to 24 port-based VLAN groups or up to 32 IEEE 802.1Q VLAN groups. On the other hand, the MTU VLAN divides port 1 to port 24 as separate LAN group. Via supporting port trunking, the FNSW-2400PS allows the operation of a high-speed trunk to combine multiple ports. The FNSW-2400PS also provides two groups of up to 4-Port 10/ 100Base-TX trunk support with up to 800Mbps bandwidth per trunk group.
Physical Port • 24-Port 10/100Mbps Fast Ethernet ports with PoE Injector • Reset button for system management Power over Ethernet • Complies with IEEE 802.3af Power over Ethernet Mid-Span PSE • Up to 24 IEEE 802.3af devices powered • Supports PoE Power up to 15.4 watts for each 802.3af PoE port • Auto detects powered device (PD) • Circuit protection prevents power interference between ports • Remote power feeding up to 100m Layer 2 Features • Auto-MDI / MDI-X detection on each RJ-45 port • Prevents packet loss with back pressure (half-duplex) and IEEE 802.3x pause frame flow control (full-duplex) • Supports VLAN: –IEEE 802.1Q Tag-based VLAN –Port-based VLAN –MTU VLAN (Multi-Tenant Unit VLAN) • Supports Link Aggregation –up to 2 trunk groups –up to 4 Fast Ethernet ports per trunk group –IEEE 802.3ad LACP (Link Aggregation Control Protocol) • Supports Spanning Tree Protocol –STP, IEEE 802.1D (Classic Spanning Tree Protocol) –RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol) –Loopback Detection • Port mirroring to monitor the incoming or outgoing traffic on a particular port Quality of Service • 2 priority queues on all switch ports • Traffic classification: –Port-based priority –IEEE 802.1p based priority –IP TOS / DSCP based priority –TCP / UDP Port-based QoS • Strict priority and Weighted Round Robin (WRR) CoS policies • In/Out rate limit control on each port • Broadcast Storm Control support Multicast • Supports IGMP Snooping v1 and v2 Security • MAC address filter • TCP & UDP filter on each port • Management idle time security Management • Remote Web interface for Switch management and setup • Supports SNMP v1 • Supports DHCP Option 82 and DHCP Relay • Firmware upgrade through Web interface • Configuration upload / download through Web interface • Reset button for system reboot or reset to factory default |
Hardware Specifications | |
Ports | 24 10/100Base-TX RJ-45 auto-MDI/MDI-X interfaces |
Switch Processing Scheme | Store-and-Forward |
Throughput (packet per second) | 3.57Mpps@64Bytes |
Switch Fabric | 4.8Gbps |
Address Table | 8K entries |
Share Data Buffer | 1.75Mb embedded memory for packet buffers |
Flow Control | Back pressure for half duplex, IEEE 802.3x pause Frame for full duplex |
Dimensions (W x D x H) | 445 x 207 x 45 mm (1U height) |
Weight | 2.55kg |
Power Requirements | 100~240V AC, 50-60 Hz, 2A |
Power Consumption / Dissipation | Max.135 watts / 460 BTU |
Smart Functions | |
System Configuration | Web interface, SNMP v1 |
Port Configuration | Port speed duplex mode selection Port Disable / Enable |
Bandwidth Control | Yes |
Broadcast Storm Control | Yes |
Port Statistics | Display each port’s details about Ethernet traffic counter information |
VLAN | 24 port-based VLAN groups / 32 IEEE 802.1Q VLAN groups / MTU VLAN |
Spanning Tree Protocol | STP, IEEE 802.1D (Spanning Tree Protocol) RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol) |
Port Trunking | 2 groups of 4-port 10/ 100Base-TX trunk support, up to 800Mbps bandwidth per trunk group |
Port Mirroring | Port mirroring allows monitoring of the traffic across any port in real time |
QoS | Allows to assign low / high priority on each port First-In-First-Out, All-High-before-Low, Weight-Round-Robin QoS policy |
MAC Address / TCP & UDP Filter | Yes |
IGMP Snooping v1 / v2 | Allows to Disable or Enable |
Power over Ethernet | |
PoE Standard | IEEE 802.3af Power over Ethernet / PSE |
PoE Power Supply Type | Mid-Span |
PoE Power output | Per Port 48V DC, 350mA . Max. 15.4watts |
Power Pin Assignment | 4/5(-), 7/8(+) |
PoE Power Budget | 125 watts |
Standards Conformance | |
Regulation Compliance | FCC Part 15 Class A, CE |
Standards Compliance | IEEE 802.3 Ethernet IEEE 802.3u Fast Ethernet IEEE 802.3af Power over Ethernet (15.4Watts) IEEE 802.3x full-duplex flow control IEEE 802.1Q VLAN IEEE 802.1p QoS IEEE 802.1D Spanning Tree Protocol IEEE 802.1w Rapid Spanning Tree Protocol |
Environment | |
Temperature | Operating: 0~50 degrees C Storage: -10~70 degrees C |
Humidity | Operating: 5~95% Storage: 5~95% (non-condensing) |
Department / Workgroup PoE Switch With 24 10/100Mbps ports, the FNSW-2400PS provides a cost-effective and high-performance solution for power users. With its 4.8 Gigabits per second, non-blocking switch fabric, this device can easily provide a local, high bandwidth Fast Ethernet network for your departmental backbone. Providing up to 125 watts of PoE budget, in-line power interface, the FNSW-2400PS helps the administrator to flexibly build a power centrally-controlled IP phone system, IP camera system and AP group for the enterprise. For instance, 24 cameras or wireless APs can be installed around the corner in the company for surveillance or wireless roaming demands. Without the power-socket limitation, the FNSW-2400PS makes the installation of cameras and wireless LAN AP more efficient. |